User guide

Component Failure Recovery
96-30052-001 Rev. A4 DataDirect Networks StorageScaler 8460 User Guide | 47
3.2.5 Replacing a LCD Module
NOTE : The LCD module is not a redundant component, but the enclosure will
remain operational if the LCD module is broken or if it is removed.
The LCD FRU kit includes the LCD PCBA and the cable
(Figure 52).
To replace the LCD module:
1. Detach the bezel from the enclosure by removing the four screws from behind.
2. Detach the LCD PCBA and cover from the front panel by removing the four screws as
shown in Figure 53.
3. Disconnect the cable from the system.
4. Place the new module on the front panel, replace the cover, and use the four screws to
secure them.
5. Connect the new module’s cable to the system.
6. Replace the bezel.
Figure 52. LCD FRU Kit
Figure 53. Remove Screws from LCD Module
Unplug Cable