Installation manual

IQ3 Data Logger Dash Installation Manual

Setting the Start/Finish Location

There are two methods you can use to set the start/finish location. The first method is to use

the external programming buttons. The second method is to use the DataLink software to

write the start/finish location to the microSD card. The second method is explained later in the

manual. To set the set start/finish position using the external programming buttons perform

the following:

1) Press and hold Button 1 for 3 LED flashes or until the text SET START/FINISH appears on

the bottom of the display.

2) Drive the vehicle at a speed no less than 10 MPH towards the start/finish location.

3) Press and release Button 1 (1 LED flash) at the point you wish to set the start/finish.

4) The dash will respond YES if successful and NO if unsuccessful.

Reviewing Lap Times (Lap Time Replay Mode)

You can review your lap times from the previous session by entering in to Lap Time Replay

Mode. To enter Lap Time Replay Mode enter a long button press (3 flashes) on button 2. The

text “Lap Replay Mode” will display across the bottom of the display. While in Lap Time Replay

Mode buttons 1 and 2 will perform the following functions.

Type of Button Press Button 1 Button 2

Short Press – 1 flash Decrement Lap Number Increment Lap Number

Medium Press – 2 flashes Jump to Best Lap Exit Lap Time Replay Mode

Long Press – 3 flashes Jump to First Lap Jump to Last Lap

DataLink II Software Installation

Data Download Path

The key to understanding the DataLink software utilized by the IQ3 is to understand the

relationship between the downloaded data, the IQ3 Configuration file and the DataLink

software.

Raw Data from IQ3

MicroSD memory card

Configuration File in

DataLink Software

Datalink II Software