Installation manual

IQ3 Data Logger Dash Installation Manual

Track Map Creation (Open - Autocross, Solo & Hill Climb)

Through the use of GPS signals, it is possible to create a track map, even if the start and finish

line are located at two different locations. In the previous section, we located the vehicle at the

desired start / finish and selected the Set Lap Start button. For open course, we need to also

establish an end point of the lap, also. To create an open course track map, we will refer to the

previous section and follow the same instructions for Step 1. Resuming at Step 2:

Step 2: Select Track Type

For open course, select Open Course.

Step 3: Set Lap Start

Set Lap End / Open Course Only

As discussed in the previous section, the current data in view represents the GPS position of the

vehicle from the start until the end of recording. If you were to place the mouse cursor in the

Main Graph area, (insure GPS_MPH is still graphed and the entire run is in view) then left click

and drag the mouse curser through the Main Graph area, you can follow the location of the

vehicle in the GPS driving line data.

To Set Lap Start, place the mouse

cursor in the Main Graph area, left click

and move the vehicle location (as noted

by the small X) in the GPS map data

until the approximate start area is

located. Next, select the Set Lap Start

button. Then, move the cursor to the

desire end of the course and select the

Set Lap End button.

Step 4: Create GPS Trackmap

Finally, select the Create GPS Trackmap button. This action now completes the GPS track

mapping process.