Installation manual

IQ3 Data Logger Dash Installation Manual

Step 3: Manually Edit Segments

It is also possible to manually name a particular turn, override the assigned name to a particular

area of the track or creating additional segments by using the Manual Segment Edit. To do so:

1. Position the location of the vehicle (as noted by the X on the track map) in the desired

change area. Select Divide. Move the cursor to the desired ending point of the change

select the Divide button again.

2. Place the location of the vehicle between the newly selected Diving markers and choose

the desired action: Corner / Straight / Merge / Extend / Divide and the DataLink II

software will perform the desired changes.

Road course: We have found it is helpful to obtain a top view of the race course (most are

available on the Internet) and duplicate their nomenclature for corners and straights. This

agreement between maps will greatly assist, when discussing particular track areas.

Circle Track: To create a four turn track, place the mouse cursor in the Main Graph area and

move the vehicle location to the center of turn 1, then select the Divide button. Next, place the

mouse cursor in the Main Graph area and place the vehicle location in the center of the

opposite turn and select the Divide button. This action will now provide a four turn track.

Additional segments may be created by placing the vehicle in the desired location and

continuing to divide the track map.

Remember, any segment added to the track map provides timing information, which aids in

data analysis.

To manually insert segment markers at desired locations on the track map, position the vehicle

at the desired location for the entrance segment marker and select the Divide button. Next,

move the vehicle to the desired exit segment marker and again select the Divide button. Then,

place the vehicle position between the two segments markers that are in view on the track map

and select the Corner button.