Installation manual

IQ3 Data Logger Dash Installation Manual

Add Inside / Outside Track - Optional

When utilizing GPS data, it is possible to create on-screen inside and outside track edges, to

assist in reviewing data. To obtain data for inside / outside driving lines, it is necessary to drive

at least two complete laps on the inside of the track and two complete laps on the outside of

the track. If the start / finish area is not passed at least two times during each procedure, a

suitable lap will not be obtained.

It is advisable to obtain inside and outside track information at some point during an on-track

run and utilize this same run for track mapping, segmentation and inside / outside track

creation. Then, by using the following instructions, the user simply toggles through the available

laps, selecting the desired inside and outside laps.

Following the creation and segmentation of a trackmap, open the Add Inside/Outside Track-

Optional Runlog page:

Step 1:

Toggle through the available laps, until a suitable inside lap is obtained. Select the Create

Inside Track

button.

Step 2:

Toggle through the available laps, until a suitable outside lap is obtained. Select the

Create Outside Track button.

Following these procedures, the inside and outside track area should now be represented by

red and blue lines, on the GPS track map graphic area. To save the updated track, select the

Create GPS Track Map Runlog page, then the SELECT/CREATE GPS MAP button. This action will

open the Select/Create GPS MAP dialog window. Select the Rename/Save Lap File button. The

user can save with the existing track map name or rename as desired.