Installation manual

IQ3 Data Logger Dash Installation Manual

External Sensors

The IQ3 Logger Dash utilizes Racepak’s Vnet (canbus) sensor input. This design provides the

ability to transmit all sensor data through a single cable. This cable is connected to the 5 pin

Vnet port on the rear of the dash. No sensor wiring harness is required.

To add sensors, the customer simply measures from the IQ3 dash to the mounting location of

the sensor or sensors, and orders the appropriate length pre-terminated Vnet extension cable.

Vnet cables are available in 12” increments and are equipped with a male connector on one

end and a female connector on the opposite end. In the event sensors are mounted in multiple

location throughout the vehicle, simple measure between each sensor location and order the

necessary Vnet extension cables to connect all items to the main Vnet cable routed to the rear

of the dash.

Any Vnet sensor currently offered by Racepak may be utilized by the IQ3 Logger Dash. For a

complete listing of available sensors, visit our website located at www.racepak.com or contact

the Racepak customer service department at 949-709-5555 for a catalog. Customer supplied

sensors may also be utilized. Racepak’s USM module (PN: 230-VM-USM) is a four sensor input

module, providing the ability to define each sensor input dependant sensor type.

Sensor

Vnet Cable