User Manual
Table Of Contents
- Introduction
- Getting Started
- Simple Tests
- Quantitative Quantitative Tests
- Transmitter Only Transmitter Only
- Receiver Only
- Loopback Test Mode
- Configuration Commands
- Built-in-Self Test (BIST) Routines
- Miscellaneous Test Routines
- Persistent Store Keys
- Appendix 1 BIST Parameters
- Appendix 2 Known Software Issue(s) in BlueTest Version 1.4
- Appendix 3 Combining Tests Using a Second Unit
- Appendix 4 Configuration Commands Available During Tests
- Appendix 5 Bluetooth Packet Types
BlueTest Instruction Manual
bc01-an-047b
© Copyright CSR Ltd 2001
This material is subject to CSR’s non-disclosure agreement.
Page 38 of 56
BlueCore
TM
01
Title IF RESP
Summary
Sweeps transmit IF carrier frequency over designated number of
samples (n_samples) within range (0-3MHz maximum) and
measures RSSI. Returns table of RSSI value against frequency
offset to characterise IF filter response.
Test
Arguments
No. of Samples(n_samples) = 0 to 65535 (default = 10)
Start (lo_offset) = 0 to 3MHz (default 0.001 MHz)
Finish (hi_offset) = 0 to 3 MHz (default = 3.000
MHz. Must be greater than lo_offset)
Return Data A sequence of reports of RSSI and frequency offset.
Exit Click on Reset Chip.
IF RESP Example Display