User's Manual

STARModem™
8
UK/US
INTERFACE SELECTION
Select the desired interface string for your application, then set the correct hardware
jumper position (see "STARModem™ Initial Setup" for jumper setting).
Among the following interface selection strings, send only the string that suits
your application:
Jumper
Position
RS232 Interface
$+CP0$-CR
1
Pen Emulation Interface
$+CP6$-CR
2
Wedge Interface
IBM AT or PS/2 PCs
$+CP500$-CR
2
IBM XT
$+CP503$-CR
2
PC Notebook
$+CP505$-CR
2
IBM SURE1
$+CP506$-CR
2
IBM Terminal 3153
$+CP504$-CR
2
IBM Terminals 31xx, 32xx, 34xx, 37xx
To select the interface for these IBM Terminals, send the correct KEY
TRANSMISSION string. Select the KEYBOARD TYPE if necessary (default =
advanced keyboard).
Make-only keyboard
$+CP502$-CR
2
Make-break keyboard
$+CP501$-CR
2
Advanced keyboard
$+FK1$-CR
2
Typewriter keyboard
$+FK0$-CR
2
ALT MODE
The ALT-mode selection allows barcodes sent to the PC to be interpreted correctly
independently from the Keyboard Nationality used. You do not need to make a
Keyboard Nationality selection.
(default = Num Lock Unchanged).
Make sure the Num Lock key on your keyboard is ON.
IBM AT- ALT mode
$+CP507$-CR
2
PC Notebook - ALT mode
$+CP508$-CR
2
Wyse Terminal - ANSI Keyboard
$+CP509$-CR
2
Wyse Terminal - PC Keyboard
$+CP510$-CR
2
Wyse Terminal - ASCII Keyboard
$+CP511$-CR
2
Wyse Terminal - VT2200 style Keyboard
$+CP514$-CR
2
APPLE ADB Bus
$+CP513$-CR
2
Digital Terminal VT2xx/3xx/4xx
$+CP512$-CR
1