User's Manual

GRYPHON™ BT SH3500
8
3
3.3 OM-GRYPHON™ BT SH3500 CABLE CONNECTIONS
The OM-Gryphon™ BT SH3500 incorporates a multi-standard interface which can be
connected to a Host by simply plugging an RS232, USB or Wedge emulation cable
into the Host connector, placed on the base of the cradle. In addition the cradle must
be connected to an external power supply.
To connect the OM-Gryphon™ BT SH3500:
1. Connect the OM-Gryphon™ BT SH3500 to the appropriate interface cable which
must be simply plugged into the Host connector on the base of the cradle.
2. Connect the cradle to an external power supply, see the figure below.
Bottom View
To disconnect the cable, insert a paper clip or other similar object into the hole
corresponding to the Host connector on the body of the cradle. Push down on the clip
while unplugging the cable. Refer to the following figure:
Disconnecting the Cable
Host Interface Cable
Power Supply