User's Manual
Table Of Contents
- CONTENTS
- UPDATES AND LANGUAGE AVAILABILITY
- USING QUICKSCAN™ M GUN AND CRADLE
- SYSTEM CONNECTIONS
- QUICKSCAN™ M CRADLE CONFIGURATION
- QUICKSCAN™ M READER CONFIGURATION
- INTERFACE SELECTION
- USB INTERFACE CONFIGURATION
- USB INTERFACE SELECTION
- RS232 INTERFACE SELECTION
- WEDGE INTERFACE SELECTION
- USB / WEDGE KEYBOARD NATIONALITY
- PEN INTERFACE SELECTION
- OPERATING TEST
- READER DEFAULT CONFIGURATION
- CRADLE DEFAULT CONFIGURATION
- TECHNICAL FEATURES
- WARRANTY
- PATENTS
- SERVICES AND SUPPORT
- COMPLIANCE
- READING DIAGRAM
- NUMERIC TABLE
- DECLARATION OF CONFORMITY
QUICKSCAN™ MOBILE
QUICKSCAN™ M CRADLE CONFIGURATION
The QuickScan™ M cradle configuration can be performed in two ways: either
by sending configuration strings from the Host via the RS232 or USB-COM
interface or by reading configuration barcodes with the reader.
Serial/USB COM Configuration
By connecting the QuickScan™ M cradle to a PC through an RS232 or USB
cable (only USB-COM interface) it is possible to send configuration strings from
the PC to the reader. Using this method you can also send new configuration
strings from the PC to the reader or upgrade application software onto the
reader.
QUICKSCAN™ M READER CONFIGURATION
When the QuickScan™ M cradle is connected and powered, configure the
QuickScan™ M reader by reading the following codes in the given sequence and
follow the instructions.
Note: for the numeric code selection of step 3, use the table at the end of this
Quick Reference Guide.
Restore QuickScan™ M default
1.
Ì$+$*oÎ
Enter configuration
2.
Ì$+;Î
Set Radio Address
3.
ÌRF8Î
+
four digits for the QuickScan™ M Address
(from 0000 to 1999).
All readers used in the same area must have different addresses.
Exit and Save configuration
4.
Ì$-?Î
7