User's Manual
Table Of Contents
- CONTENTS
- UPDATES AND LANGUAGE AVAILABILITY
- USING QUICKSCAN™ M GUN AND CRADLE
- SYSTEM CONNECTIONS
- QUICKSCAN™ M CRADLE CONFIGURATION
- QUICKSCAN™ M READER CONFIGURATION
- INTERFACE SELECTION
- USB INTERFACE CONFIGURATION
- USB INTERFACE SELECTION
- RS232 INTERFACE SELECTION
- WEDGE INTERFACE SELECTION
- USB / WEDGE KEYBOARD NATIONALITY
- PEN INTERFACE SELECTION
- OPERATING TEST
- READER DEFAULT CONFIGURATION
- CRADLE DEFAULT CONFIGURATION
- TECHNICAL FEATURES
- WARRANTY
- PATENTS
- SERVICES AND SUPPORT
- COMPLIANCE
- READING DIAGRAM
- NUMERIC TABLE
- DECLARATION OF CONFORMITY
QUICKSCAN™ MOBILE
USING YOUR QUICKSCAN™ M READING SYSTEM
Follow the procedure below to start using your QuickScan™ M reading system:
1. Connect a QuickScan™ M cradle to the Host. For installation and
connection information see page 5.
2. Insert the QuickScan™ M gun into the cradle to start the battery charging.
A full charge of the Lithium battery takes 3.5 – 6 hours.
NOTE
To achieve the best battery life, it is recommended to perform a
full battery charge before using the gun in hand-held mode.
In hands-free use, you can immediately start using the gun, since it is
powered by the cradle.
3. Configure the QuickScan™ M gun.
4. Configure the QuickScan™ M cradle. See QuickScan™ M cradle
configuration at page 7.
CHANGING THE BATTERIES
To change the battery of your reader, you must:
1. Unscrew the battery cover screw (Figure 1)
2. Unplug the white connector and remove the old battery (Figure 2)
3. Insert the new battery and plug in the white connector
NOTE
When inserting the new battery into the handle pay attention to
position the battery and the connector just as shown in Figure 3.
Figure 1 Figure 2 Figure 3
3