User Manual

DATALOGIC MEMOR™

4.2 CHARGING THE BATTERY PACK

The battery pack autonomy varies according to factors, such as the frequency

of barcode scanning, RF usage, etc.

The battery icon on the Status Bar indicates when the battery pack is low.

It is possible to recharge the battery pack by connecting the power supply

directly to the Datalogic Memor™.

Alternatively, it is also possible to recharge the battery pack by using the

Datalogic Memor™ Single Cradle.

Moreover recharging is possible by USB Direct connection with the host

computer, but with longer charging times and in this case it is advised to keep

the mobile computer off.

During the charging process the LED positioned at the right side of the display

is red constant. Once the charging process has been completed this LED is

green constant (see par. 3.4).

If the battery pack is removed from the mobile computer, it can be recharged by

inserting it into the rear slot of the Datalogic Memor™ Single Cradle.

CAUTION

If the battery pack is new or has not been recharged for a

long time, it is necessary to perform two or three charging

and discharging cycles (complete use) before it can reach

its maximum charge capability.

The maximum time required to recharge a completely run-

down battery pack is about 3 hours if the mobile computer

is idling.