Integration Guide

Author: Radio Group
Date: February 11
th
, 2014
Revision: March 4
th
, 2015
Subject: Integration Guide – Mizar Radio Module 915 MHz
Page 9 of 11
Federal Communications Commission (FCC) Statement
You are cautioned that changes or modifications not expressly approved by the part responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause undesired
operation of the device.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your
body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
In accordance with KDB 447497 D01, section 4.3.1, this module is exempt from Head/Body SAR testing
when installed in a host product with a Head/Body to antenna separation distance of ≥ 17mm.
If the module is to be used with a smaller separation distance than the above, SAR testing must be
performed.
In accordance with KDB 447497 D01, section 4.3.1, this module is exempt from Extremity SAR testing when
installed in a host product with a Extremity to antenna separation distance of ≥ 7mm.
If the module is to be used with a smaller separation distance than the above, SAR testing must be
performed.
Industry Canada (IC) Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
In accordance with RSS-102, section 2.5.1, this module is exempt from Head/Body SAR testing when
installed in a host product with a Head/Body to antenna separation distance of ≥40mm.
If the module is to be used with a smaller separation distance than the above, SAR testing must be
performed.