Author: Radio Group Date: February 11th, 2014 Revision: March 4th, 2015 Subject: Integration Guide – Mizar Radio Module 915 MHz Integration Guide Mizar Radio Module 915 MHz Page 1 of 10
Author: Radio Group Date: February 11th, 2014 Revision: March 4th, 2015 Subject: Integration Guide – Mizar Radio Module 915 MHz Table of contents Document history ...................................................................................................... 3 Regulatory:................................................................................................................. 4 Introduction .......................................................................................................
Author: Radio Group Date: February 11th, 2014 Revision: March 4th, 2015 Subject: Integration Guide – Mizar Radio Module 915 MHz Document history Date Author Notes April 19th, 2012 May 2nd, 2012 May 31th, 2012 July 18th, 2012 April 15th, 2013 Davide Carli Davide Carli Davide Carli Davide Carli Davide Carli December 20th, 2013 Davide Carli January 15th, 2014 February 11th, 2014 Davide Carli Pier Giorgio Peruzzi Initial draft Added details on test command(s) 0x86 In-depth documentation of test comman
Author: Radio Group Date: February 11th, 2014 Revision: March 4th, 2015 Subject: Integration Guide – Mizar Radio Module 915 MHz Regulatory FCC regulation Interference warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.
Author: Radio Group Date: February 11th, 2014 Revision: March 4th, 2015 Subject: Integration Guide – Mizar Radio Module 915 MHz Le présent émetteur radio (identifier le dispositif par son numéro de certification ou son numéro de modèle s'il fait partie du matériel de catégorie I) a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne.
Author: Radio Group Date: February 11th, 2014 Revision: March 4th, 2015 Subject: Integration Guide – Mizar Radio Module 915 MHz Introduction Mizar radiofrequency (RF) module operates in the 902-928 MHz ISM frequency band.
Author: Radio Group Date: February 11th, 2014 Revision: March 4th, 2015 Subject: Integration Guide – Mizar Radio Module 915 MHz Antennas The module has been approved with the antennas listed below: Datalogic, part number 663316020 – 902-928 MHZ Helical Antenna – gain 1dBi, impedance 50Ω Antenna Factor, model ANT-916-CW-QW – gain 3dBi, impedance 50Ω Bondale Electronics, model G-RA0K14155047 – gain 1dBi, impedance 50Ω Datalogic, part number ANTENNA CABLE GM4100-910 – gain -4,5dBi, impedance 50
Author: Radio Group Date: February 11th, 2014 Revision: March 4th, 2015 Subject: Integration Guide – Mizar Radio Module 915 MHz decodes it and sends decoded data to the Host by means of the UART interface. Only valid demodulated data packets are sent to the Host. Transmission State This state is enabled from the host when it needs to transmit data. The transmission state is enabled sending a data packet to the radio module over the UART interface.
Author: Radio Group Date: February 11th, 2014 Revision: March 4th, 2015 Subject: Integration Guide – Mizar Radio Module 915 MHz Electrical characteristics Table 1 Parameter Min. Typ. Max. Unit Power supply voltage (between VCC pin and GND pin) 3,1 3,3 3,6 V Operating temperature range -30 --+85 °C RF characteristics Low speed mode Table 2 Parameter Typ.
Author: Radio Group Date: February 11th, 2014 Revision: March 4th, 2015 Subject: Integration Guide – Mizar Radio Module 915 MHz High speed mode Table 6 Parameter Typ.
