User's Manual

DATALOGIC JET™

Alternatively using the stylus, you can tap once directly on the value on the right

column; continue tapping until the desired value is reached.

To activate a new configuration select the File ->Save Menu to send the new

configuration to the barcode decoding software and save the new configuration. This

will save the configuration to non-volatile memory preventing loss at the next system

reset.

Reader Parameters

The barcode reading parameters and values are dependent upon the type of scanner

module mounted in your PDA. For a detailed list of parameters and of their

configuration procedures, please refer to the SDK Help file on the CD.

Scan Parameters

The Scan Parameters are common to all scanner modules and allow control of the

scanning device. The Scan parameters are described as follows:

ScanTimeout: the maximum time, in milliseconds, during which the scanner remains

on without decoding any barcode.

GoodReadSound: is the filename of a .wav file played when the scanner reads a

code.

LedDuration: the length of the good-read led pulse, in milliseconds.

LedPulses: the number of times the good-read led pulse is emitted when the

scanner reads a barcode.

ContinuousMode: when enabled, the scanner can only be turned off by releasing

the SCAN key, or if Soft Trigger is enabled, by the application program. Continuous

Mode overrides Scan Timeout.

KeyboardEmulation: if enabled all scanned data are transformed into keyboard

events and can therefore be displayed and saved to a file as if input from the PDA

keyboard. If set to “Yes (Clipboard)”, it copies the scanned data to the system

clipboard.

SoftTrigger: when enabled, the laser can be turned on/off by the application

software.

ScanAlwaysOn: enables the scanner for barcode reading independently from the

application software. If set to “Disabled after read”, it disables the reading after a

reading attempt. In case the scan button is accidentally pressed, this selection

prevents the driver from decoding new data while the application is still elaborating

previous data.

NotPrintableChar: if set to “Remove”, all not printable characters included in the

scanned data are deleted and the final barcode will include only printable characters.