User's Manual

USE AND FUNCTIONING
9
3
3.2 DATA CAPTURE
To capture data first of all select the barcode icon on the bottom-right side of
the
display and tap the 'Capture' menu item then proceed with the following
directions.
To configure and enable data capture parameters refer to par. 3.5.
3.2.1 Laser Data Capture
To scan barcodes, point the Datalogic Joya™ laser model onto the code from a
distance within the reading range while pressing the “Up” key.
The lighted band emitted by the laser must completely intercept the barcode as
shown in the figure below. If enabled, the emission of an acoustic signal will
indicate that the scan has taken place correctly.