User's Manual

DATALOGIC MEMOR™
74
1 4
4 MAINTENANCE
NOTE
Rechargeable backup batteries and battery packs are not
initially charged. Therefore the initial operation to perform is
to charge them. See below.
CAUTION
Annual replacement of rechargeable battery pack avoids
possible risks or abnormalities and ensures maximum
performance.
4.1 CHARGING THE BATTERY PACK
NOTE
The battery pack autonomy varies according to many factors,
such as the frequency of barcode scanning, RF usage, battery
life, storage, environmental conditions, etc.
The battery icon on the Taskbar indicates when the battery pack is low.
It is possible to recharge the battery pack by connecting the power supply
directly to the Datalogic Memor™.
Alternatively, it is also possible to recharge the battery pack by using a Single
Cradle.
Moreover recharging is possible by USB Direct connection with the host
computer, but with longer charging times and in this case it is advised to keep
the mobile computer off.
During the charging process the LED positioned at the right side of the display
is red constant. Once the charging process has been completed this LED is
green constant (see par. 3.5).
If the battery pack is removed from the mobile computer, it can be recharged by
inserting it into the rear slot of a Single Cradle.
CAUTION
Do not use the Datalogic Memor™ until batteries are
charged for minimum 4 hours.