User's Manual

Code 39
Code
Parameter
Description
I.D.#
Accept.
Input
Defaults Scanner Type
Min
Max
Factory
Laser
2D Imager
Lorax
Enter 1 for On and 0 for Off
Enable
Enables/disables the Code
39 symbology.
0100 On or Off Off On On √ √ √
Enable
Aggressive
Decoding
Enables more aggressive
decoding algorithms to be
used in order to scan hard
to read labels.
0101 On or Off Off On Off √
Enable
Checksum
Requires the use of
checksum characters to
verify a bar code.
0102 On or Off Off Off Off √ √ √
Send
Checksum
Instructs the terminal to
include the checksum in
the label transmission.
0103 On or Off Off Off Off √ √ √
Full ASCII
Mode
Supports the entire ASCII
character set by replacing
various encoded ASCII
characters with their
corresponding.
0105 On or Off Off On On √ √ √
Minimum
Label
Length
Set the minimum label
length to be less than or
equal to maximum label
length.
0120 01 - 50 01 01 01 √ √ √
Maximum
Label
Length
This feature specifies the
maximum allowable length
of a Code 39 label. The
length includes check and
data characters. Maximum
Label Length should be
greater than or equal to
Minimum Label Length.
0121 01 - 50 01 50 20 √ √ √
Read
Verification
Sets the number of times a
label must be read before
it is transmitted.
0122 01 - 04 01 02 01 √ √
User ID
Specifies the symbology
identifier (if any) that is
sent when parameter
Send Code ID (Index
0025) is set to 3. ASCII
code zero (null) is used to
indicate that an identifier is
not to be sent for the
symbology.
0123
Any
single
ASCII
character
(00 = Off)
‘C’ ‘C’ ‘C’ √ √ √