User's Manual

IMAGING CONTROLS
Code
Parameter
Description
I.D.#
Accept.
Input
Defaults
Scanner
Type
Min
Max
Factory
2D Imager
Enter 1 for On and 0 for Off
Imager
Illuminate
Enable
Instructs the PDT to
illuminate the scanning
area (independent of any
targeting beam) when using
an imager.
0008 On or Off On On On √
Imager Aim
Mode
Toggles between two
different operating modes
for the targeting beam:
Concurrent (Off): The
targeting beam is turned on
at the same time as an
enabled illumination beam.
Interlaced (On): Toggles
the aimer and illumination
beam.
0009 On or Off On On On √
Enable Aiming
Beam
Enable the use of a target
beam.
000A On or Off On On On √