Technical information

112 Maintenance AccuLazr™ AL5010 Product Line Manual
Verify Reader Operation
Follow the Operations Checklist procedure defined in Chapter 5.
If the reader parameters were changed to read bar codes other than the
factory defaults, simply use a good quality bar code to assist in verifying
proper operations. There is no need to return the reader to the default
parameters to perform this test.
Verify Photoeye Operation
1. Block the photoeye beam to confirm it is aligned properly with the
reflector.
2. If the LED on the photoeye changes status, the photoeye is functioning
properly.
Trigger Photoeye – Status LED Location
3. Verify that the Trigger LED on reader is green when photoeye beam is
blocked.
4. If the photoeye’s LED does not change
status, adjust the photoeye so
that it is properly aligned with the reflector.
5. If the Trigger LED on the reader is not green when the photoeye’s beam
is blocked, check the cabling between the photoeye and reader
mounting base for damage.
Verify Tachometer Operation
There are two ways to verify tachometer operations.
Use AccuLazr User Interface
1. Establish a connection with the reader.
2. Go to Diagnostics > Monitor.
3. Verify the Belt Speed is accurate when the conveyor is running.
Use Tach LED in Enhanced Interface Module
1. Locate the Tach LED.
2. Slowly spin the tachometer wheel.
3. Verifying the tach LED in the mounting base is flashing.
Accu-Sort Systems, Inc. 07-AL5010_Maintenance_R20.doc