Technical information

128 Troubleshooting AccuLazr™ AL5010 Product Line Manual
Discovering the IP Address
If you don’t know the IP address for the AL5010 unit, it can be found in two
ways.
To Discover the IP Address Using Recovery Mode:
1. Unplug the power to the AL5010 system.
2. Hold down the “!” button on the back of the reader while you restore
power.
3. Release the button. The LEDs should strobe from 5 to 1 and the status
LED will be RED indicating that the unit is in Recovery Mode.
4. Open a browser and type 192.168.3.100 in the address bar.
5. The AL5010 recovery screen opens. The screen displays the IP address
for the unit as well as the user name and password for the User
Interface.
6. Note the IP address for the unit and click REBOOT. The AL5010 reboots
and the AL5010 Login screen opens.
To Discover the IP Address Using a Terminal Emulation Program:
1. Connect a laptop computer to one of the serial blocks in the interface
module (Basic or Enhance) using a serial cable with flying leads (See the
Electrical Installation section of this manual).
NOTE: Make sure the baud rate, stop bits, etc match the serial
port to which you are connected.
2. Launch a terminal emulation program on your laptop computer (i.e.:
HyperTerminal, Tera Term, etc.)
3. Type IpAdDr in the terminal emulation program. If everything is set up
correctly, the IP address will be displayed.
NOTE: Since these processes are performed with a direct
connection to the individual reader, there are no security
issues.
Accu-Sort Systems, Inc. 08-AL5010_Troubleshooting_R20.doc