Technical information

AccuLazr
™
AL5010 Product Line Manuals Mechanical Installation 23
13. In Modify Settings > Raster, gradually increment your upper and
lower sweep values toward 0%. Try 5% increments first, i.e.: Set
both the Upper Sweep and Lower Sweep to -15, then -10, -5, 0, 5,
and etc. The laser should intersect a barcode at each degree setting.
14. Check the read quality on the monitor at each increment. The quality
should be 100%.
15. Continue incrementing the upper and lower sweep settings until the
scan line reaches or goes just beyond the level of the highest
barcode.
16. In Modify Settings > Raster, set the lower sweep at -20 and the
upper sweep to the value determined in step 15.
03-AL5010_Mechanical_Installation_R20.doc Accu-Sort Systems, Inc.