Technical information

AccuLazr
™
AL5010 Product Line Manuals Mechanical Installation 25
Run Test Labels
1. Configure the scanner for your application by setting up
communications, barcode types, triggers and relays as applicable to
your system (See Chapter 5 Setup).
2. In the user interface, navigate to Diagnostics > Monitor.
3. Place a test barcode at the front edge of the box in the lowest
position and run the box through the system.
4. Check the Monitor screen to see how the barcode reads. The
quality will likely not be 100%, but it is just important that it reads.
5. Next, place the test barcode at the front edge of the box in the
highest position and run the box through the system.
6. Again, check the Monitor screen to make sure the barcode has
been read.
03-AL5010_Mechanical_Installation_R20.doc Accu-Sort Systems, Inc.