Technical information

AccuLazr
™
AL5010 Product Line Manuals Mechanical Installation 29
Installing an AL5010 Scan Head
Perform the electrical installation as outlined in Chapter 4. Once all wiring is
checked for accuracy, install the AL5010 scan head to the mounting base.
You can install the scan head with or without the power disconnected from
the mounting base.
To install a scan head:
1. Carefully align the scan head (1) alignment tabs to the mounting base.
This automatically assures the correct scan head-to-mounting base
connector alignment.
2. Gently, press the scan head down until it firmly connects with the
connector in the mounting base (2).
3. Tighten the two captive screws to secure the scan head to the base.
Do not over tighten.
4. Adjust the UMB so the reader’s laser exit window faces the approximate
location of where the bar-coded packages will appear.
AL5010 Scan Head Installation on Mounting Base
03-AL5010_Mechanical_Installation_R20.doc Accu-Sort Systems, Inc.