Technical information

40 Electrical Installation AccuLazr™ AL5010 Product Line Manual
Multiple Readers with a Single Interface Module
General Electrical Installation Guidelines and Precautions
It is important that you follow these general precautions when installing,
setting up, operating, maintaining, troubleshooting or replacing any Accu-Sort
products, parts or related equipment.
CAUTION: The AL5010 use lasers for bar code scanning. Do not view
directly with optical instruments (binoculars or telescopes). Avoid
unintentional exposure to laser light whenever possible.
As you plan and install your AL5010 bar code solution application, be sure to
keep the following guidelines in mind:
 Determine the reader is in the proper orientation and position as outlined
in Chapter 3.
 Leave adequate clearances (approximately 8-12 inches [203.2-
304.8mm]) for wiring.
 The interface modules have several cord grip openings. Seal unused
openings with rubber grommet plugs (units ship with rubber plugs in
place). Remove the grommet plugs when inserting cables. Use cord
grips with rubber grommets on cables that enter the interface module.
 Route wires carefully to reduce or minimize electrical noise. The
interface modules are designed so power and communication wiring
should not need to cross.
WARNING: To assure no ESD damage will occur, be sure to observe the
precautions outlined in Chapter 2, Safety.
Accu-Sort Systems, Inc. 04-AL5010_Electrical_Installation_R20.doc