Technical information

48 Electrical Installation AccuLazr™ AL5010 Product Line Manual
Tachometer Connections
In applications where product tracki
ng is required, a tachometer is typically
used. When a tachometer is required, the Accu-Sort tachometer is
recommended. Connect the tachometer wiring to the interface module
terminal blocks.
Wiring Tachometer to the Enhanced Interface Module
WARNING: The maximum tachometer current should not be more than
0.3 amps @ 24 volts.
If your application uses a tachometer other than the one available from Accu-
Sort, follow the TACH wiring table to assure proper wiring.
Multiple Readers In controller/client applications, wire the tachometer to
the AL5010
set up as the controller. (See drawing in Appendix F.)
Accu-Sort Systems, Inc. 04-AL5010_Electrical_Installation_R20.doc