Technical information

56 Electrical Installation AccuLazr™ AL5010 Product Line Manual
Check installations using Enhanced Interface Module:
1. Plug in the power supply.
2. Check the following:
3. Power ‘on’ (POWER LED)
 Trigger photoeye operation (TRIGGER LED)
 Tachometer operation (TACH LED)
 Serial communications, receive data
(RX1, RX2 LEDs)
 Input Relay (if applicable, I/O 1 LED).
4. Finger-tighten all water-tights.
5. Install cover.
6. Tighten four Phillips screws.
Do not over tighten.
Accu-Sort Systems, Inc. 04-AL5010_Electrical_Installation_R20.doc