Quick Reference Guide

Datalogic S.r.l.
Via S. Vitalino, 13
40012 Calderara di Reno (BO)
Italy
Tel. [phone]
Fax [phone]
©2022 Datalogic S.p.A. and/or its affiliates
All rights reserved. Without limiting the rights under copyright, no part of this
documentation may be reproduced, stored in or introduced into a retrieval sys-
tem, or transmitted in any form or by any means, or for any purpose, without the
express written permission of Datalogic S.p.A. and/or its affiliates.
Owners of Datalogic products are hereby granted a non-exclusive, revocable
license to reproduce and transmit this documentation for the purchaser's own
internal business purposes. Purchaser shall not remove or alter any proprietary
notices, including copyright notices, contained in this documentation and shall
ensure that all notices appear on any reproductions of the documentation.
Electronic versions of this document may be downloaded from the Datalogic
website (www.datalogic.com). If you visit our website and would like to make
comments or suggestions about this or other Datalogic publications, please let
us know via the "Contact" page.
Disclaimer
Datalogic has taken reasonable measures to provide information in this manual
that is complete and accurate, however, Datalogic shall not be liable for technical
or editorial errors or omissions contained herein, nor for incidental or conse-
quential damages resulting from the use of this material. Datalogic reserves the
right to change any specification at any time without prior notice.
Trademarks
Datalogic and the Datalogic logo are registered trademarks of Datalogic S.p.A. in
many countries, including the U.S.A. and the E.U.
PowerScan is a trademark of Datalogic S.p.A. and/or its affiliates, registered in
the U.S. All other trademarks and brands are property their respective owners.
Patents
See www.patents.datalogic.com for patent list.
This product is covered by one or more of the following patents:
Utility patents: EP1873886B1, EP2382502B1, EP2517148B1, EP2649555B1,
EP2795534B1, US7948214, US8743263, US8888003, US8915443, US9430689,
US9482793, US9569653, US9798948, US10025966, US10496858, US10817685,
US10915476, US10915719, ZL200780030808.2, ZL200880132595.9,
ZL200980163411.X, ZL201080071124.9.
REGULATORY INFORMATION
All models are designed to be compliant with rules and regulations in locations
they are sold and will be labeled as required.
Any changes or modifications to equipment, not expressly approved by Datalogic
could void the user's authority to operate the equipment.
Statement of Agency Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation. Any change or modification to the product not
expressly approved by Datalogic could
void the user's authority to operate the device.
FCC Class B Compliance Statement
The user is cautioned that changes or modifications not expressly approved by
the part responsible for compliance could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential instal-
lation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to cor-
rect the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio or television technician for help.
Base Charger BC96xx-910
FCC
To comply with FCC RF exposure compliance requirements, for mobile configura-
tions, a separation distance of at least 20 cm must be mantained between the
antenna of this device and all persons.
IC
Canada Notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may
cause undesired operation of the device.
3. A separation distance of at least 20 cm must be maintained between the
antenna of this device and all persons to comply with the safety require-
ments for mobile RF exposure conditions in accordance with RSS-102 Issue
5.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d'Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux conditions suivantes:
1. L'appareil ne doit pas produire de brouillage;
2. L'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
3. Une distance de séparation d'au moins 20 cm doit être maintenue entre
l'antenne de cet appareil et toutes les personnes afin de respecter les exi-
gences de sécurité relatives à l'exposition aux RF dans des conditions d'util-
isation mobile, conformément à la norme RSS-102 Version 5.
Reader PowerScan PM96xx
Canada Notice
RF Exposure Safety According to "RSS-102 Issue 5 (2015-03) - Radio Frequency
Exposure Compliance of Radiocommunication Apparatus (All Frequency Bands)",
paragraph "2.5.1 Exemption Limits for Routine Evaluation - SAR Evaluation", the
device operates below the applicable output power level (adjusted for tune-up
tolerance) for the specified separation distance. The evaluation has been done at
a distance of 5mm.
CAUTION: Exposure to Radio Frequency Radiation
PowerScan™ PM9600 reader,
BC9600-433 base charger and
BC9600-910 base charger
REGULATORY ADDENDUM
Preliminary Rev. May 2022
©2022 Datalogic S.p.A. and/or its affiliates • All rights reserved •
Without limiting the rights under copyright, no part of this documen-
tation may be reproduced, stored in or introduced into a retrieval sys-
tem, or transmitted in any form or by any means, or for any purpose,
without the express written permission of Datalogic S.p.A. and/or its
affiliates • Datalogic and the Datalogic logo are registered trade-
marks of Datalogic S.p.A. in many countries, including the U.S. and
the E.U.
This document is an addendum to the Quick Reference
Guide (QRG) for this product. See the QRG for additional
product information.
www.datalogic.com
Industrial Cordless Handheld
Area Imager Bar Code Reader
Sécurité d'exposition aux RF Selon " RSS-102 Édition 5 (2015-03) - Conformité à
l'exposition aux fréquences radio des appareils de radiocommunication (toutes
les bandes de fréquences) ", paragraphe " 2.5.1 Limites d'exemption pour l'évalu-
ation de routine - Évaluation SAR ", l'appareil fonctionne ci-dessous le niveau de
puissance de sortie applicable (ajusté pour la tolérance de mise au point) pour la
distance de séparation spécifiée. L'évaluation a été faite à une distance de 5 mm.
FCC
Radiofrequency radiation exposure Information:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance of 5mm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter
Frequency Band Used (only for 433 MHz devices)
433,050-434,790 MHz
Maximum output power
< 10 dBm
Power Supply
This device is intended to be connected to a UL Listed/CSA Certified computer
which supplies power directly to the device or else be supplied by UL Listed/CSA
Certified Power Unit marked "Class 2" or LPS power source rated 10-30V mini-
mum 1.5A.
Argentina Power Supply Statement
DEVICE LABELING
Sample labels are shown here to illustrate their location only. Please
view the labels on your product for actual details, as they may vary from
those depicted.
Scanner Regulatory Label
Base Regulatory Label
Customs Union
The CU conformity certification has been achieved; this allows
the Product to bear the Eurasian mark of conformity.
Características de la fuente de alimentación
eléctrica.
Atención
Entrada:
100 - 240 Vca
min 400mA 50-60 Hz
Salida:
12VDC, máx1500mA
(-) Negativo al centro
Utilice en su red solo fuentes certificadas en Argentina.
El uso de fuentes de alimentación no compatibles puede resultar en
riesgo de incendio o de choque eléctrico para el usuario.
Aiming System
Output Window
433 MHz devices