Instruction manual

RAPID CONFIGURATION
1
1 RAPID CONFIGURATION
STEP 1 – CONNECTING THE SYSTEM
To connect the system in a Stand Alone configuration, you need the hardware indicated in
Figure 1. In this layout the data is transmitted to the Host on the main serial interface.
The RS232 auxiliary interface can be used for reader configuration by connecting a laptop
computer running VisiSet™.
When One Shot or Phase Mode Operating mode is used, the reader is activated by an
External Trigger (photoelectric sensor) when the object enters its reading zone.
PG 6000
CB
X
Figure 1 – Matrix-2000™ in Stand Alone Layout
Matrix-2000™
Main Interface
CAB-Sxx
Terminal
Local Host
* External Trigger or Presence Senso
r
(for On Shot or Phase Mode)
P.S.*
1