Instruction manual

READING FEATURES

The Internal Lighting Mode parameter allows to set the operating mode of the internal

lighting system. The possible values are:

• Disabled: the built-in LED array is turned off all the time. This option can be useful if using

an external lighting system;

• Always ON: the built-in LED array is turned on all the time at the lowest power level. This

option is useful if the LED-array blinking (Strobed operating mode) disturbs the operator.

• Very High/High/Medium/Low-Power Strobed: the built-in LED array is on only during the

image exposure time. Four different lighting levels can be set.

NOTE

To avoid LED array overheating, for Power Strobed settings, the program

automatically limits the range of allowed values for the Exposure Time

parameter. Therefore, after changes to Internal Lighting Mode, recheck

Exposure Time.

CAUTION:

The maximum target speed in the application is affected by these conditions:

• Code/Background Contrast: maximum speed decreases when decreasing image

contrast (poor quality codes, reflective transparent coverings, different supports and

printing techniques).

• Code Resolution: maximum speed increases when decreasing code resolution (there is

a decrement of overlapping effects between two adjacent elements).

• Tilt Angle: maximum speed decreases when increasing Tilt angle (from 0 to 45

degrees).