Instruction manual

TYPICAL LAYOUTS
6
Alternatively, the Master scanner can commun
icate to the Host as a Slave node on a
Fieldbus network. This requires using an accessory Fieldbus interface board installed inside
the CBX500 connection box.
System configuration can be accomplished through the Auxiliary interface of the Master
reader (internal CBX500 9-pin connector) using the VisiSet™ configuration program or Host
Mode programming.
3
Po
wer
Slave#1 Slave#n
2
Master
1
Host
 Fieldbus Interface
 External Trigger (for One Shot or Phase Mode)
 ID-NET™ (up to 16 devices - practical limit)
Figure 93 – ID-NET™ Fieldbus M/S Synchronized Layout
4
Master Slave#1 Slave#n
Power
2
Terminal
 Fieldbus Interface
 Auxiliary Serial Interface (Local Echo) (RS232)
 External Trigger (for One Shot or Phase Mode)
 ID-NET™ (up to 32 devices, max network extension of 1000 m)
3
1
Host
Figure 94 – ID-NET™ Fieldbus M/S Multidata
77