Instruction manual

MATRIX 200™ REFERENCE MANUAL

8.4 CONFIGURATION

Once connected to Matrix 200™ as described in par. 8.3, you can modify the configuration

parameters as follows:

1. Press the C

alibration Tool button from the Main Menu. Matrix 200™ will download its

permanent memory configuration parameters with the default values (if it is the first time)

to VisiSet™. The Calibration Tool window will be displayed together with the Parameter

Setup window working in Interactive Mode (see par. 8.4.1 and par. 8.4.3).

2. Edit the

Matrix 200™ configuration parameters according to your application

requirements.

3. Use the Calibration Tool to fine tune the reading performance. See par. 8.4.3.

4. Close the Calibration Tool window and disable the Interactive Mod

e by pressing the

interactive button.

5. Save the new configuration to the reader permanent memory by pressing the Send

button.

6. Close the Parameter Setup window and press Disconnect on the VisiSet™ menu bar

(see Figure 99) or launch Run Mode

from the VisiSet™ Main menu.

Disconnect exits closing communication between Matrix 200™ and VisiSet™

, and

causes Matrix 200

™ to enter Run Mode. The disconnected reader serial port is now

available.

Run command does not close communication between Matrix 200™ and VisiSet™

and causes Matrix 200™ to enter Run Mode. In this case the reader output messages

are displayed on the VisiSet™ terminal and the statistics are displayed in the

Statistics window (Statistics enabled).