User`s manual

DL TCL™ EXTENDED COMMANDS
29
4
4 CONFIGURING FROM TERMINAL
Once the DL TCL™ application and configuration files have been downloaded onto
the terminal by using the DL Mobile Configurator™ Enterprise 2 program, it is
possible to change the value for most of the defined parameters directly from the
terminal. This operation is suggested when modifying a few parameters
. If you need
to change most of the downloaded configuration, we advise to use the DL Mobile
Configurator™ Enterprise 2 program (refer to the relevant manual for further details).
To change the configuration from the terminal, a series of configuration menus is
available.
The main setup menu may be entered by following one of the given procedure:
- when launching the DL TCL™ program for the first time, after terminal rebooting,
the program opening mask appears. By pressing the [ESC] key and inserting the
password (see Figure 31), the main setup menu will be displayed (see
Figure 32);
- by pressing the “Exit Emulation Key” ([F10] is the default value) it is possible to
quit the terminal emulation at any time and display the opening mask and then
the main setup menu. This procedure requires exiting all sessions (see par.
4.2.3);
- if no Host PC or KC PC is available for radio communication, the program
automatically displays the opening mask and then the main setup menu.
The following keys allow navigating within the configuration menus:
- [Enter]:
if pressed, it validates the selection. When navigating through
the menus it jumps to an upper level within the same page, or
jumps to another mask if the selection is displayed in several
pages.
- [Numeric Keys]:
if pressing the key corresponding to the number next to each
option, it is possible to select its value. If the selection is
exclusive or multiple, the defined option will be displayed in
reverse video. In case of more complex options, the numeric
key press opens another mask showing options belonging to
a lower level.
- Arrow Keys:
if pressed, they increase / decrease a numeric value within a
defined range or scroll all available values of non-numeric
parameters.
The main setup menu is shared by all Datalogic RF portable terminals. Different
parameters will be signaled.