User`s manual

DL TCL™
32
4
4.2.1 TCP/IP
If selecting this submenu, the following masks appear allowing to define the IP
parameters related to the terminal.
"1"
[ENTER]
[ENTER]
Datalogic - SETUP
Network Settings
1) TCP/IP
2) Radio
3) Connection
ENTER to Continue
Datalogic - SETUP
Network TCP/IP 1/2
1) IP Address
2) Subnet Mask
3) Gateway Address
ENTER to Continue
Datalogic - SETUP
Network TCP/IP 2/2
4) DNS Address
5) Device Name
ENTER to Continue
Figure 34 - TCP/IP Diagram
 IP Address
The IP Address may be defined either manually (static), through DHCP (Dynamic
Host Configuration Protocol) or through BOOTP (Bootstrap Loader):
Datalogic - SETUP
Network IP Address
1) Static
2) Enable DHCP
3) Enable BOOTP
ENTER to Continue
Figure 35 - ID Address Selection
When defining the address manually (Static selection), the following mask appears:
Datalogic - SETUP
Network IP Address
- Static IP Address:
ENTER to Continue
Figure 36 – Defining Static IP Address