User`s manual

DL TCL™
38
4
When configuring the radio, the "Out of Range" option (set [AUTO]) allows DL TCL™
to automatically signal if during data transmission a terminal is out of the area
covered by the Access Point. For all terminals this condition will be signaled by the
LED activation, while for Rhino™ terminal the signal is emitted by the beeper. If set
to [ON], it is possible to verify this condition only if trying to transmit from the terminal.
In all these cases, the following message is displayed:
OUT OF RANGE
Retry? ( Y/N )
Radio
Card Model
Settings
IEEE 802.11b Wi-Fi
Cisco 340/350
- SSID = sets the Service Set Identifier of the specific
wireless network
- Power Options = specifies the Power Save Mode,
where CAM corresponds to Constant Awake Mode,
PSP to Power Save Mode and FASTPSP to Fast Power
Save Mode
IEEE 802.11b Wi-Fi
Lucent/ARTEM
W-Card 11 ComCard 11
- Wireless Network Name = sets the Service Set
Identifier of a specific wireless network. When this
parameter is omitted, or is specified as an empty string
or as “ANY”, the station may connect to any network
- Card Power Management = enables or disables the
terminal use of the Power Management. Specifying 2
enables Enhanced Power Management, specifying 1
enables the Standard Power Management, while
specifying 3 disables the Power Management
IEEE 802.11b Wi-Fi
Symbol Spectrum
24 High Rate
- ESS ID = sets the Service Set Identifier of a specific
wireless network
- Performance Index = selects the power saving mode by
inserting a number between 0 and 5, where 0 sets the
consumption of most power at maximum speed, and 5
sets the consumption of least power at minimum speed.