User`s manual

DL TCL™
42
4
4.3 EMULATION MENU
This menu allows setting the parameters managing the terminal emulation:
Datalogic - SETUP
Emulation
1) General
2) VT100/VT220
3) 3270/5250
ENTER to Continue
Figure 49 - Emulation Menu
4.3.1 General Parameters
Datalogic - SETUP
Emulation
1) General
2) VT100/VT220
3) 3270/5250
ENTER to Continue
Datalogic - SETUP
1) AutoRun OFF
2) TCP KeepAlive
3) DL-TCL Scroll O
N
4) Log Enable OFF
ENTER to Continue
"1"
[ENTER]
"2"
[ENTER]
Datalogic - SETUP
TCP KeepAlive
1) TCP KeepAlive OFF
2) Timeout
ENTER to Continue
"2"
[ENTER]
Datalogic - SETUP
KeepAlive Timeout
- Timeout:
ENTER to Continue
Figure 50 – General Settings
 AutoRun
It enables/disables the terminal automatic connection at program startup or on
closure/connection failure. If enabled, the program enters the opening mask and after
3 seconds tries to connect to the PC automatically. Once connected, it is possible to
enter the main setup menu by pressing the [ESC] key before a 3 sec. timeout
expires.
 TCL KeepAlive
It enables/disables TCL KeepAlive function. This function allows the terminal to send
a NOP (no operation) packet to the Host at regular intervals in order to maintain the
radio connection.
Even if the terminal goes into suspend mode it automatically wakes up after
the timeout interval to send the NOP packet.