User`s manual

DL TCL™ EXTENDED COMMANDS
49
4
4.4.2 Display
The Display submenu allows defining the font dimension to be used for terminal
emulation and the backlight management.
[
Datalogic - SETUP
Device Settings
1) Input/Output
2) Display
3) Beeper
ENTER to Continue
Datalogic - SETUP
1) Font Selection
2) Backlight
3) Cursor
4) Scrolling Modes
ENTER to Continue
"2"
[ENTER]
Datalogic - SETUP
4) Wide (40x12)
5) Bold (40x10)
6) DBold (40x08)
7) Custom Font
ENTER to continue
[ENTER]
Datalogic - SETUP
Display Backlight
1) Auto ON
2) Timeout
ENTER to continue
Datalogic - SETUP
Display Cursor
1) Block
2) Underline
ENTER to continue
Datalogic - SETUP
Display Fonts 1/2
1) Normal (64x12)
2) Small (80x25)
3) Medium (40x16)
ENTER to Continue
“1”
“2”
[ENTER]
“3”
[ENTER]
[ENTER]
Datalogic - SETUP
1) Fixed
2) Quadrant Mode
3) Center Cursor
4) Locked
ENTER to continue
“4”
[ENTER]
Figure 55 - Display Diagram
 Font
A list of 7 font types is available, where six font types are fixed and one can be
customized by the user. For each font type is reported the maximum number of
characters (columns x lines). The defined font will be adopted as soon as the
terminal emulation is started. Once the emulation session is closed, the font selection
is restored to the default value. In the following table all fonts are listed according to
the terminal model:
Rhino™ LCD Rhino™ VFD Viper™ Kyman™ F7400 / F7400-E
Normal (64x12) Normal (25x8) Normal (24x20) Normal (20x20) Normal (13x6)
Small (80x25) Small (32x16) Small (30x20) Double (10x12) Small (16x8)
Medium (40x16) Medium (25x16) Dbold (15x13) Dbold (10x10) Double (9x5)
Wide (40x12) Wide (16x12) Double (15x16) Medium (16x15) Dbold (8x4)
Bold (40x10) Bold (16x10) Xsmall (30x34) Xsmall (20x26) Xsmall (24x8)
Dbold (40x8) Dbold (16x8) Thin (24x26) Thin (16x20) Thin (12x8)
Custom Custom Custom Custom Custom