User`s manual

INSTALLATION
3
2
2 INSTALLATION
2.1 INSTALLING DL TCL™ ONTO THE TERMINAL
Once the DL Mobile Configurator™ Enterprise 2 has been installed (see relevant
manual), it is possible to set and configure the DL TCL™ application and download
the related files onto your terminal.
Figure 3 – DL Mobile Configurator™ Enterprise 2 Main Window
For a correct and complete downloading, you must define the parameters available in
the configuration tree. In particular you must set the “Download Selection” parameter
to DL TCL™ for downloading this application.
Once you have set all the parameters required by your DL TCL™
application, it is
necessary to enable the communication between the DL Mobile Configurator™
Enterprise 2 and the terminal by following one of the procedures given below:
- Connection through the RS232 port:
From the DOS prompt run the command DS [Bx], where x is one of the following
baud rate speeds:
5 = 9600 bps
6 = 19200 bps
7 = 38400 bps (default speed of the DTPS communication protocol)
8 = 57600 bps
9 = 115200 bps (default speed of the DL Mobile Configurator™ Enterprise 2)
- Connection through Cradle:
Extract the terminal from its cradle, then, from the DOS prompt run the
command DC [Bx], where x is one of the following baud rate speeds:
5 = 9600 bps
6 = 19200 bps
7 = 38400 bps (default speed of the DTPS communication protocol)
8 = 57600 bps
9 = 115200 bps (default speed of the DL Mobile Configurator™ Enterprise 2)
After setting the required baud rate, insert the terminal back in the cradle and
the message “Start Server...” will appear on the display.
Configuration Tree