Installation manual

RAPID CONFIGURATION

STEP 3 – X-PRESS™ CONFIGURATION

X-PRESS™ is the intuitive Human Machine Interface designed to improve ease of

installation and maintenance.

Status and diagnostic information are clearly presented by means of the five colored LEDs,

whereas the single push button gives immediate access to the following relevant functions:

 AutoSetup to self-optimize and auto-configure

reading performance in demanding applications

 AutoLearn to self-detect and auto-configure for

reading unknown barcodes (by type and length)

 Test Mode with bar-graph visualization to check

static reading performance

NOTE

If using the OM2000N accessory, when entering the X-PRESS™ interface,

the Oscillating Mirror remains in the default fixed position (-15°) in order to

make barcode reading easier while performing the X-PRESS™ functions.

The colors and meaning of the five LEDs are illustrated in the following table:

READY (green)

This LED indicates the device is ready to operate. For Subzero models

this LED blinks during the warm-up phase.

GOOD (green) This LED confirms successful reading.

TRIGGER (yellow) This LED indicates the status of the reading phase. *

COM (yellow) This LED indicates active communication on main serial port. **

STATUS (red) This LED indicates a NO READ result.

* In On-Line mode the TRIGGER LED corresponds to the active reading phase signaled by the Presence Sensor.

In Automatic and Continuous modes the TRIGGER LED is always on indicating that the reader is ready to read a

code.

** When connected to a Fieldbus network through the CBX500, the COM LED is always active, even in the

absence of data transmission, because of polling activity on the Fieldbus network.

During the reader startup (reset or restart phase), all the LEDs blink for one second.

On the back of the reader near the cable, the “POWER ON” LED indicates the laser scanner

is correctly powered.