Installation manual

DS2400N REFERENCE MANUAL
28
3
3.2.2 Mounting a GFC-2010 Accessory Direct Output Window
The GFC-2010 accessory direct output window can be used as a replacement of the original
output window in case of damage over time when used in harsh environments.
CAUTION
Subzero model scanners must not be opened in an uncontrolled
environment.
The installation of the output window is very easy.
1. Make sure the device is not powered.
2. Remove the original 0° scanning window
from the scanner by unscrewing the two
cover screws.
Cover Screws
Figure 15 - Removing the 0° Scanning Window
CAUTION
Avoid any contact with the mirrored rotor, the lenses or other optical
components; otherwise the performance of the reader will be reduced.
3. Clean the reading window with a clean soft cloth and alcohol before closing the scanner.
4. Mount the GFC-2010 accessory so that the opening face is at 0° with respect to the
scanner body. Tighten the two cover screws.
Figure 16 - Mounting a GFC-2010 Direct Output Window
The reading position with respect to the scanner is shown below.
Laser Beam
GFC-2010
0° ± 2°
Figure 17 - GFC-2010 Laser Beam Output Position