Operation Manual

Digital Output Enter/Exit Programming Mode
Product Reference Guide 71
Deactivation Event
Defines the event deactivating the output. See "Wrong Code String" on page 266 in
“References” for more information about this feature.
$COUD100\r
Disable
DEFAULT
$COUD101\r
Timeout
$COUD102\r
Reading Phase Active
Deactivation Timeout
When Timeout is the selected Deactivation Event, this specifies the maximum duration of the
output pulse.
$COUT1
Set Deactivation Timeout
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE barcode above, then the barcode at left fol-
lowed by the digits (in hex) from the Alphanumeric
charac
ters in Appendix E, Keypad representing your
desired character(s). Exit programming mode by scanning
the ENTER/EXIT barcode
again.
Make a mistake? Scan the CANCEL barcode to abort and not
sav
e the entry string. You can then start again at the begin-
ning.
~
CANCEL
DEFAULT
005 = 500 msec