Operation Manual
Table Of Contents
- Introduction
- Setup
- Configuration Using Bar Codes
- Configuration Parameters
- Global Interface Features
- RS-232 Interface
- RS-232/USB-Com Interfaces
- Keyboard Settings
- USB-OEM Interface
- IBM 46XX Interface
- Wand Emulation Interface
- Data Format
- Reading Parameters
- Double Read Timeout
- LED and Beeper Indicators
- Scanning Features
- Scan Mode
- Stand Mode Indication
- Stand Operation
- Pick Mode
- Stand Mode Sensitivity
- Stand Mode Illumination Off Time
- Scanning Active Time
- Stand Illumination Control
- Motion Still Timeout
- Flash On Time
- Flash Off Time
- Aiming Pointer
- Aiming Duration Timer
- Green Spot Duration
- Mobile Phone Mode
- Partial Label Reading Control
- Decode Negative Image
- Image Capture
- Corded Only Features
- Multiple Label Reading
- 1D Symbologies
- 1D Code Selection
- Disable All Symbologies
- Code EAN/UPC
- UPC-E
- GTIN Formatting
- EAN 13 (Jan 13)
- ISSN
- EAN 8 (Jan 8)
- UPC/EAN Global Settings
- Add-Ons
- Code 39
- Trioptic Code
- Code 32 (Ital Pharmaceutical Code)
- Code 39 CIP (French Pharmaceutical)
- Code 39 Danish PPT
- Code 39 LaPoste
- Code 39 PZN
- Code 128
- GS1-128
- Code ISBT 128
- Interleaved 2 of 5 (I 2 of 5)
- Interleaved 2 of 5 CIP HR
- Follett 2 of 5
- Standard 2 of 5
- Industrial 2 of 5
- Code IATA
- Codabar
- ABC Codabar
- Code 11
- GS1 DataBar™ Omnidirectional
- GS1 DataBar™ Expanded
- GS1 DataBar™ Limited
- Code 93
- MSI
- Plessey
- 2D Symbologies
- WIRELESS FEATURES
- Bluetooth-Only Features
- FEATURES FOR STAR MODELS ONLY
- Motion Features
- References
- Message Formatting
- Technical Specifications
- Standard Defaults
- Sample Bar Codes
- Keypad
- Scancode Tables
Product Reference Guide
303
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column of the table below.
Page references are also provided for featu
re descriptions and programming bar codes for each
parameter. A column has also been provided for recording of
your preferred default settings for
these same configurable features.
Table 53. Standard Defaults
Parameter Default Your Setting
Page
Number
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore
Obey 39
USB Suspend Mode
Disable 39
RS-232 ONLY
Baud Rate
9600 42
Data Bits
8 Data Bits 43
Stop Bits
1 Stop Bit 43
Parity
None 44
Handshaking Control
RTS 45
RS-232/USB-Com
Intercharacter Delay
No Delay 47
Beep On ASCII BEL
Disable 47
Beep On Not on File
Enable 48
ACK NAK Options
Disable 49
ACK Character
‘ACK’ 50
NAK Character
‘NAK’ 50
ACK NAK Timeout Value
200 ms 51
ACK NAK Retry Count
3 Retries 51
ACK NAK Error Handling
Ignore Errors Detected 52
Indicate Transmission Failure
Enable 52