Operation Manual

Installation
User Manual 9
Verification
The Datalogic JavaPOS installer automatically installs a POSTest application
for testing all kinds of JavaPOS devices. If one of the previously discussed
Datalogic/Datalogic scanners or scales is available, you can test the drivers
to make sure they were installed correctly.
There are shell scripts in the /opt/dls/Java
POS directory that can be used
to run POSTest or JEREditor.
You can run POSTest from a command prompt or terminal window by issu-
ing the following command:
java com.jpos.POStest.POStest.jar
There is a new script that can be used to start POSTest:
POStest.sh (.csh) is located in the JavaPOS directoy (depending upon
which shell is used).
If this command does not launch the application, the CLASSPATH is
probably not configured properly. Restart your computer and try again.
After POSTest starts, the following screen is displayed:
Most of the devices listed by this application are not yet supported. This
procedure only addresses the Scale and Scanner devices.