User's Manual

DATALOGIC JOYA™ X2
10
0
1 5
5.5 JOYA™X2/JOYA CRADLE DISPENSER CONNECTION
JOYA Cradle Dispenser is equipped with an electrical-serial connection, used
to exchange command and response with JOYA™ X2. The communications
between the terminal inserted into the slot and the slot itself are performed by
means of a special “RPC like command-response” protocol.
5.6 CONFIGURATION
JOYA Cradle Dispenser should be previously configured using an apposite
program: JOYA Cradle Tool (see SDK Help for more information).
In a typical application there is the need to identify in a unique way each cradle
slot, in order to be able to perform selective operations. This requirement is
satisfied by each JOYA Cradle Dispenser slot, by means of a set of four
parameters, called Config Parameters:
Slot ID: is a string of 2 bytes
Dispenser ID: is string of 1 byte
IP address: is a string of …bytes
Port ID: is a string of 2 bytes
Using this four byte strings it is possible to setup and identify each slot in a
unique way.
This Config Parameters are stored in the permanent memory location
dedicated of each slot. They can be configured making use of the JOYA Cradle
Tool and they can be read by a well inserted JOYA™ X2.
5.7 USE AND FUNCTIONING
Insert a JOYA™ X2 inside a slot, JOYA Cradle Dispenser will lock the JOYA™
X2, when electrical connectors are contacted.
To unlock JOYA™ X2, approach a magnet to the sensitive area and extract the
JOYA™ X2.