User's Manual

USE AND FUNCTIONING
67
3
3.13 STYLUS CALIBRATION
You might need to recalibrate the touch screen (i.e. when you attempt to select
one item with the stylus, another item is erroneously selected).
To recalibrate the touch screen, complete the following steps:
1. Select Start > Settings > Control Panel > Stylus to open the Stylus
Properties dialog as shown in Figure 1.
2. Select the Double-Tap tab to adjust the sensitivity, if needed or desired.
3. Select the Calibration tab to open the Calibration application.
4. Tap Recalibrate to open the Calibration screen shown in Figure 2.
5. Carefully press and briefly hold stylus on the centre of the target. Repeat
as the target moves around the screen. Press the <ESC> key to cancel
the stylus calibration.
6. Press the <ENTER> key or tap the screen to accept the new calibration
settings. Press the <ESC> key to keep the old settings.
7. New calibration settings are persistently saved in registry.