Operation Manual

Interface Related Features
58 Magellan
TM
1100i
Keyboard Wedge — cont.
Intercharacter Delay
START / END
PROGRAMMING BARCODES
One-half of the delay specified below is inserted between scancodes within each character. If the transmis-
sion speed is too high, the system may not be able to receive all characters. You may need to adjust the
delay
to make the system work properly. Selectable from 00 to 99 in 10msec increments.
To configure this feature, scan the “START/END” barcode above to place the unit in Programming Mode,
th
en the “Set Intercharacter Delay,” followed by the three digits (zero padded) from the Alphanumeric table in
Appendix C, Alpha-Numeric Pad representing your desired length. Exit programming mode by again scanning
the “START/END” barcode above/
DEFAULT SETTING FOR THIS FEATURE:
0
0 (No Delay)
Set Intercharacter Delay
USB COM Interface Set-up
This interface uses the Microsoft Windows USB COM driver. Before plugging your reader
into the host PC, please ensure you have already copied the DLS_EUG_CDC_ACM.inf file
provided by Datalogic to your PC and the reader’s interface is set to USB COM.
1. When you first plug the scanner into the PC, W
indows will bring up the “Found New
Hardware Wizard.” Select “Install from a list” and click on “Next.”
2. Click on “Include this location in the
search” and enter the path where the file
DLS_EUG_CDC_ACM.inf file is stored. Click on “Next.”
3. If a message appears that says the software has not
passed Windows logo testing, press
“Continue” anyway.
4. Click on “Finish.”
5. Once the install is complete, reboot the PC.