Operation Manual

2-10 Magellan
TM
8300/8400
Service Access
The scanner and scanner/scale have been engineered to allow performance
of all routine service and maintenance (such as “zeroing” and calibration)
without removing the scanner from the checkstand. Additionally all cable
connections made at the scanner can be connected and removed while the
unit is sitting on the countertop. The installer should provide service
access to all remaining cable connectors as well as the AC/DC Power Sup-
ply (if installed).
Power Installation
Plug your scanner into an electrical outlet that has been wired to meet all
applicable electrical codes, laws, and regulations and has a common
ground with the Point-of-Sale terminal
Grounding
The AC/DC Power Supply should have an AC outlet with a clean earth
ground. If you are not sure how to verify the amount of electrical noise
(interference) on the power line, ask a qualified electrician to measure the
input line voltage.