Operation Manual

A-2 Magellan
TM
8300/8400
LED and Beeper Indications
Scanner and Scale LEDs
The Scanner LED indicates scanner status, and the Scale LED (which is in
combination with the Scale push button) is primarily used to show scale
status (see
Table A- 1).
Table A-1. Scanner and Scale LED Indications
LED
INDICATION
DURATION COMMENT
Scale at Zero
a
Scale (Yellow) LED on steady
The scale is at rest and reads zero weight.
The scale is ready to weigh.
Scanner
Active
a
(Normal
Mode)
Scanner (Green) LED on steady
and dim
The scanner is ready for operation. Scanning
is immediately available.
Good Read
Indication
a
Scanner (Green) LED - bright
flash
Indicates a bar code has been read and
decoded.
Program
Mode
Indication
Scanner (Green) LED - Continu-
ous flashing
Indicates the scanner is in Label Program-
ming Mode. Cycle power to exit Programming
Mode.
Sleep Mode
Indication
Scanner (Green) LED flashes
slowly
The scanner motor and/or laser have auto-
matically switched off and the unit has
entered Sleep Mode due to extended inactiv-
ity.
Host Disabled
Scanner (Green) LED 1-second
off, 1/10-second on
Host has disabled scanning.
Field Replace-
able Unit
(FRU) Warn-
ing (Error
Mode)
Audible low tone 1 second.
Alternating Scanner/Scale (Green/
Yellow) LEDs flash continuously.
Serves notice that a fatal FRU failure has
been detected. Consult Error Codes in
Chapter 4 for more details. If a low tone is
heard, but continuous flashing is not
observed, the scanner can still function in a
limited capacity. Call systems support for ser-
vice in either case.