manual

Connecting the PowerScan BT8300
12 PowerScan™ BT8300
Link by Inquiry
4. To connect another PowerScan PBT8300 to the BC 8030-BT cradle,
repeat in the sequence from steps 1 through 3 before continuing. One Cra-
dle can connect with a maximum of four readers.
5. Quickly press the button (<8 seconds and release) on the BC 8030-BT cra-
dle. The yellow LED on the cradle will blink and it will search for any
PowerScan BT 8300 readers in radio range. After finishing, the cradle will
emit a beep and begin to link with PowerScan BT8300 readers found.
6. The green LED on each PowerScan BT8300 reader will blink when the
BC 8030-BT cradle tries to link with it. To confirm the connection with
the cradle, press the trigger on the reader within 10 seconds, before the
timeout expires.
7. Four ascending beeps will be emitted, signaling that the BC 8030-BT cra-
dle has been successfully connected to the PowerScan BT8300, and the
green LED on the reader will stop blinking.
8. Upon completing the connection between the reader and cradle you must
set up the correct interface for your system. Refer to the BC 8030-BT Base
Station Charger QRG for information and programming labels, and scan
the appropriate bar code to select your system’s interface type.
END of procedure. YOUR READER IS NOW READY TO READ CODES.
Link by Label
You can create a label that includes the appropriate command and the cradle
MAC address. Please refer to the Product Reference Guide (PRG), or contact
Technical Support for more information.
1.
Enter Configuration
2.
Handheld - Cradle
3.
Exit and Save Configuration