User Manual

Enter/Exit Programming Mode
254 PowerScan™ PD9530/PBT9500/PM9500
ACTION CONFIGURATION FOR FUNCTION KEYS
Configure actions (up to three) for the function keys
Configure Actions for F1
DEFAULT
$CPWEV0000\r
F1 No Actions Configured
$CPWEV
Configures Action for F1
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code for
the Function Key you want to pro
gram. Next scan 4 dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
.
The first digit must be 0; the following 3 digits must
be configured according to the CMD_ID numbers in
Table 27 on page 253 . End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
$CPWET0000\r
F2 No Actions Configured
$CPWET
Configure Actions for F2
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code for
the Function Key you want to pro
gram. Next scan 4 dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
.
The first digit must be 0; the following 3 digits must be
c
onfigured according to the CMD_ID numbers in
Table 27 on page 253 . End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the ent
ry string. You can then start again at the
beginning.
~
CANCEL
Configure Actions for F2